How To setup SETP Server Service

Article created 2005-04-04 by Hamid Ali Raja.
Last Updated 2006-12-21 by Florian Riedl
Last Updated 2011-05-23 by Tom Bergfeld

Please note that this guide is valid for WinSyslog and MonitorWare Agent. The screenshots were taken from MonitorWare Agent confuguration client.

1. First, right click on "Services", then select "Add Service" and the "SETP Server".



Once you have done so, a new wizard starts.

2. Again, you can use either the default name or any one you like. We will use "My SETP Server" in this sample. Leave the "Use default settings" selected and press "Next".

3. As we have used the default, the wizard will immediately proceed with step 3, the confirmation page. Press "Finish" to create the service. The wizard completes and returns to the configuration client.

4. Now, you will see the newly created service beneath the "Services" part of the tree view. To check its parameters, select it:



As you can see, the service has been created with the default parameters.

5. Now we still need to set a ruleset for this service to work with. Since we have no configured ruleset available at the moment, simply use the Default Ruleset, if it's not being used automatically.

Please note that IPv6 is supported since WinSyslog v11.x and MonitorWare Agent v8.x. Therefore there are also some differences in the configuration screens.
Like the mentioned IPv6 support:

6. Last, save the change and then restart the application. This procedure completes the configuration of the SETP server.



The Application cannot dynamically read changed configurations. As such, it needs to be restarted after such changes.