Show/Hide Toolbars

WinSyslog

Navigation: Configuring WinSyslog > Actions

Forward SETP Options

Scroll Prev Top Next More

This dialog controls the Send options. With the "Send SETP" action, messages can be sent to a SETP server.

 

 

actions_066

Send SETP Dialog

 

 

Servername

 

The MonitorWare Agent sends SETP to the server / listener under this name. You can either use an IPv4, an IPv6 Address or a Hostname that resolves to an IPv4 or IPv6 Address.

 

 

Default SETP Port

 

The Send SETP sends outgoing requests on this port. The default value is 5432. Set the port to 0 to use the system-supplied default value (which defaults to 5432 if not modified by a system administrator).

 

Instead of the port number, a service name can be used. If so, that name is looked up via the socket service database functions. The lookup is for protocol TCP.

 

Please note: The SETP port configured here must match the port configured at the listener side (i.e. MonitorWare Agent 3.0 or WinSyslog Enterprise edition). If they do not match, a Send SETP session cannot be initiated. The rule engine will log this to the Windows Event Log.

 

Options

 

Under this group box, you can see different options as discussed below:

 

Enable SSL/TLS

 

If this option is enabled then this action will be able to connect to SSL/TLS SETP servers. Please make sure that you want this option to be enabled.

 

Use zLib Compression to compress the data

 

It enables zLib compression support. Note that the SETP receiver must have zLib Compression support and enabled, otherwise it does not work.

 

Compression level

 

Higher level results in better compression but slower performance.

 

Session Timeout

 

The maximum time a session to a SETP server is to be kept open.

 

Advanced Connection Options

 

In this group box, you can find the options discussed below:

 

Connection Timeout

 

Maximum time a connection can take to connect or disconnect.

 

Send / Receive Timeout

 

Whern sending or receiving data, this timeout applies.

 

Please note: If this option is enabled, this action is not be able to connect to NON-SSL SETP servers.