Show/Hide Toolbars

WinSyslog

Navigation: Configuring WinSyslog > Services

Heartbeat

Scroll Prev Top Next More

The heartbeat process can be used to continuously check if everything is running well. It generates an information unit every specified time interval. That information unit can be forward to a different system. If it does not receive additional packets within the configured interval, it can doubt that the sender is either in trouble or already stopped running.

 

services_109

Heartbeat Properties

 

 

Message to Send

 

This is the message that is used as text inside the information unit. Use whatever value is appropriate. The message text does not have any special meaning, so use whatever value you seem fit.

 

 

Sleep Time

 

This is the interval, in milliseconds, that the heartbeat service generates information units in. Please note that the receiving side should be tolerant. The interval specified here is the minimum time between packets. Under heavy load, the interval might be slightly longer. It is good practice to allow twice this interval before the service is considered suspect by the system monitoring the services health.

 

 

Syslog Facility

 

The Syslog facility to be assigned to events created by the heartbeat service. Most useful if the message shall be forwarded to a syslog server.

 

 

Syslog Priority

 

The Syslog priority to be assigned to events created by the heartbeat process. Most useful if the message shall be forwarded to a Syslog server.

 

 

Syslog Tag Value

 

The Syslog tag value to be assigned to events created by the heartbeat process. Most useful if the message shall be forwarded to a Syslog server.

 

 

Resource ID

 

The Resource ID to be assigned to events created by the heartbeat process. Most useful if the message shall be forwarded to a Syslog server.

 

 

RuleSet to Use

 

Name of the rule set to be used for this service. The Rule Set name must be a valid Rule Set.