Show/Hide Toolbars

WinSyslog

There are several options, that refer to the configuration client and not the service. These can be found under File -> Options

 

clientoptions-003

 

 

General Options

 

clientoptions-001

 

Choose your language

 

You can choose from various language packs, devlivered with the client. Please note, that some languages are not fully supported and "English" is the default and suggested language.

 

 

Suppress warning when a service is deleted

 

If this iption is checked, warnings when deleting a service will be suppressed. Such a warning can occur when you try deleting a service and there is no other service using the connected ruleset.

 

 

Show autosave warning message

 

If you make changes in the configuration and switch to another component, a warning will occur if you haven't saved the changes. This warning will also allow you to directly enable auto-saving the configuration.

 

 

Always ask to reload application after language change

 

When you change the language, a popup will ask you to reload the configuration client to properly apply the changes and load with the set language.

 

 

 

Config Access

 

clientoptions-009

 

Load Configuration Registry Path

 

The Configuration Client can be switched to a different registry path for configuration. The registry path change can be made permanent here. The changed registry path is the saved within the Parameters key of the Service.

 

 

Load Configuration from File

 

Alternatively, you can configure the service to load the configuration from a file. You can set the paths with the two fields below.

 

When enabled, the configuration will always be backed up before applying the new configuration. The backup consists of the last iteration and will be placed in the same directory.

 

 

Create individual configuration files for Services

 

Can only be enabled when "Load Configuration from File" is enabled. When enabled, the Services section of the configuration will be put into a separate file.

 

 

Create individual configuration files for RuleSets

 

Can only be enabled when "Load Configuration from File" is enabled. When enabled, the RuleSet section of the configuration will be put into a separate file.